How To Use The Dymo Cleaning Card For 4xl

Cleaning your Dymo Printer Sensors

How to guide provided by Dymo support to make clean the printer sensors.

Written by Adam
Updated over a calendar week ago

In order to make clean your LabelWriter 450 printer and printer'due south sensors, delight follow the guide below.

Annotation: It is recommended by Dymo to practice this every 6 Months

i. Familiarize yourself with the photos attached which show the location of all the components you lot will need to interact with.
ii. Unplug the printer from the calculator (the USB connexion) while leaving the power cord attached.
three. Pull up the lid and remove the labels.
four. Take off the front cover from the printer, exist gentle while doing this.
5. When the front cover is off, moisten both sides of a concern card with pure alcohol. Please notice that the business organisation carte should be rigid to be properly transported by the roller. Do not soak information technology also much.
half dozen. Insert the business card under the entry sensor (ENTRY sensor photo). Run this card through the machine upward to ten times. If the machine is dirty, you will see the dirt transfer to the menu. Repeat until clean, using another if necessary.
vii. Locate the sensor every bit shown in the picture "EXIT sensor".
8. Using a dry cotton bud, clean the black chips carefully but thoroughly.
9. When done, place the front cover back on the printer.
10. Make sure that the front cover is firmly attached on all sides. There are 4 connectors that need to click when y'all put on the front cover: two hooks at the lesser and 2 notches at the meridian of the front encompass. You should hear a small-scale click when you lot have attached the front end back on and it's secure.
xi. Reconnect the printer to the reckoner and try to print a label.